Pump/ Timer Repairs

My Pool Pump Is Very Noisy

It is the pump making the noise. If the sound is grinding, it could be a pebble, or other debris, which will need to be removed from the pump. The most common cause of this condition is a failure in the motor’s bearings. These can be due to poor quality, manufactured overseas. But more often than not, there is water damage to the pump that causes moisture to build up and cause corrosion. Whatever the reason, the pool pump should not cause noise pollution and be very quiet. To diagnose the problem and find the best solution, hire a pool contractor from Beach to Bay Dive and Pools.

My Pool Pump Won’t Turn On

With the exception of spa pumps that can be manually operated, all pool circulation systems include a timer to turn off and on the pump at predetermined times. Some newer homes have programmable automation systems. These include a set of circuit breakers at the equipment pad or at the house service panel. To prevent electrocution, a GFCI may be installed in the circuit. We recommend hiring a professional to diagnose and solve the problem.

My Pool Water Doesn’t Circulate

It could be caused by a shrunken fitting getting into the inlet of your pool pump, causing it pulls in air and lose its ability to prime. This occurs when the pool water level drops too low. The pool pump will then run without water, causing the pump to heat up the little water it has and steam it. The pool pump seal and the plastic fittings (or PVC) that go in and out will shrink. This will cause another source of air. If the filter does catch the prime, water could leak from the top fitting through the seal plate onto the ground. The filter could be very dirty or have an obstruction in its suction line. Another reason to call Beach to Bay Dive and Pools for pump/timer repairs and installations is the obstruction in the suction line.